Chang™ solvent cement 500 gr

Using

1. Pipe ends and fitting sockets should be free of sand, oil, and dust. If necessary use solvent  cleaner.
2. Slightly bevel the edge of the cut pipe
3. Assemble the pipes and components dry first and mark where they should come to with a felt-tip marker.
4. Roughen the surfaces with very fine sandpaper
5. Apply the solvent cleanly and evenly on both pipe end and inside fitting socket
6. Insert pipe into socket and twist slightly to spread the cement
7. Hold the joint firmly for a few seconds
8. Do not disturb the joint for at least 5 minutes
9. Wait at least 24 hours for the solvent to fully cure before putting the joint under water pressure

CAUTION

Use in a well ventilated space