Chang™ solvent cement 500 gr

Using

• Pipe ends and fitting  sockets should be free of sand, oil, and dust. If necessary  use solvent  cleaner.
• Slightly bevel the edge of the cut pipe
• Roughen the surfaces with  very  fine sandpaper
• Apply the solvent cleanly and evenly on both pipe end and inside fitting  socket
• Insert pipe into socket and twist  slightly  to  spread the cement
• Hold the joint firmly for a few seconds
• Do not disturb the joint for at least 5 minutes
• Wait at least 12 hours for the solvent to fully cure before putting the joint under water pressure

CAUTION

Use in a well ventilated space